Posts by Cameron Dunn
Signal-to-Noise Ratio (SNR) – user protocol
INTRODUCTION Signal to Noise Ratio (SNR) is not currently offered among Raven Pro’s measurements. You can, however, estimate SNR using the Inband Power measurement in Raven. Here is one protocol for doing so. PROTOCOL Create a selection table with selections marking signals of interest. For each selection marking a signal of interest, create an companion…
Read MorePlaying Multi-channel Sounds
Specify which channels should be played back in a multichannel recording
Read MoreMulti-channel Recording
INTRODUCTION Raven Pro 1.6 and Raven Lite 2.0 do not support the recording of more than two channels at a time to make multi-channel recordings. SOLUTION #1 If you want to monitor a spectrogram and/or waveform while recording, we recommend that you use an audio application that supports multi-channel recording. One popular choice is Audacity.…
Read MoreConfiguring Audio Input
Wait for Configuring Audio Input to open …
Read MoreSignal Acquisition (Recording)
Wait for Signal Acquisition (Recording) to open …
Read More